http://www.nikonusa.com/pdf/manuals/coolpix/CP5200_en.pdfCleaning
Lens
One key to cleaning the lens is to not touch it with your fingers. Remove dust
or lint with a blower (typically a small device with a rubber bulb attached to
one end that you pump to produce a stream of air out the other). To remove
fingerprints or other stains that can not be removed with a blower, wipe the
lens with a soft cloth, using a spiral motion that starts in the center of the lens
and works out to the edges.
Monitor
Remove dust or lint with a blower. To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Avoid contact with liquid crystal
Should the monitor break, care should be taken to avoid injury due to broken glass and
to prevent the liquid crystal from the monitor touching the skin or entering the eyes or
mouth.
Body
Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth.
After using the camera at the beach or seaside, wipe off any sand or salt with
a cloth lightly dampened with fresh water, then dry thoroughly.
Do not use alcohol, thinner, or other volatile chemicals.